1. Set out the cradles at the required centres and install the battens with the joins directly over a cradle. Allow for perimeter cradles/battens at the ends of the batten runs. All perimeter cradles/battens must be isolated from the walls by at least 25mm.
2. Levelling is carried out by adjusting the 'O' support ring up and down the threads, as required. Lock by turning the carrier upstands against the battens.
3. When planning the floor layout leave a 10-15mm expansion gap around all perimeters, fix the flooring to the battens using a generous amount of Hush-Bond Panel Adhesive and secure with ring nails or screws. At the same time the flooring boards should be glued at all teegee joints board to board.
4. Press Hush-Seal 20 Perimeter Seal into the perimeter expansion gapensuring that the floor floats freely of the walls maintaining acoustic isolation or use perimeter detail as per Robust Detail instructions using Hush-RD Flanking Strip.
Full fitting instructions are supplied with all products and are available to download from the Installation Guides section.
Should you have any technical questions prior to or during installation, please call 0151 933 2026 for friendly and straightforward advice.